OmniTurn Cutting Tools
This insert can be used for general purpose turning. The .2” depth of cut can be used for most turning and facing operations.

The 45 deg. clearance on the back side of the tool can be used to undercut for a thread.
MultiBar Front turning tools
Insert #
 A
D
 R
VFTR-6M010 1
.2”
 .000
VFTR-6M040 4
.2”
 .000
VFTR-6M152 15
.2”
 .002
VFTRB-6M152* 15
.2”
 .002
VFTR-6M157 15
.2”
 .007
VFTRB-6M157* 15
.2”
 .007
* notes a chip breaker is ground onto the top edge
• Prices quoted above are for full box, 10 pc order. Inserts can be purchased in smaller quantities if available, $10 will be added to the order for "partial box charge".

• Unless requested, C-2 will be supplied.

• All prices quoted are for coated inserts. Uncoated are available, for $1.25 less.

• All inserts shown are right handed. Left handed inserts are also stocked. They are available for special applications.
MultiBar with 5/8" round shank
Torx T-7 wrench
Screw for insert - 2.40-064