|
OmniTurn announces the
introduction of the FastZip rear end loader.
OmniTurn lathes and attachments have been
designed for fast, high volume, precision
turning. Here is a loader that has been designed
to enhance the OmniTurn and make it more
productive. The loader is simple, yet it covers
a very wide range of needs for a shop with
production turning. The OmniZip can be used as a
short bar feed, then changed over to hand single
operations on long thin parts.
Features
- FAST: Part to part load
time is under 5 seconds. Much faster than
other rear end loaders that take up to 15
seconds per part
- Simple installation
- Intended for use with the
OmniTurn GT-75, OmniTurn GT-Jr., and
OmniTurn attachments.
- The OmniZip bolts to the
back of the OmniTurn and plugs into a simple
interface.
- Self contained controls
and electronics. The unit comes fully
assembled. Bolt it to the floor
Versatile:
- Load bars up to 24” long.
Perform standard bar feed type operations.
- Load a bar to a stop
on the slide
- Machine a part and
cut off
- Push the bar to the
stop for the next part
- When the bar is
complete, load the next bar
- Load individual part from
standard infeed rack for secondary
operations
- Push new part into
spindle
- Pull pusher back .1”
- Machine part
- Open collet, push
part out of collet
- Drop back, prepare to
load next part
- Load individual parts
from optional high volume add-ons.
- bowl feed adaptor -
escaped from bowl into track
- Loader mounted Bin to
hold up to 1000 parts
Compact footprint
- Adds only 5’ to the
overall length of the machine
- Only 2’ wide
· Easily removed to machine
- Can be removed easily for
storage
- Or moved from machine to
machine
· Simple to maintain and service
- Simplicity is key, all
components are available off the shelf
- Open construction aids in
setup and care
- Off the shelf, American
made electronics and components
|
