MultiBar
Turning System
Most other inserts have edges that have been pressed and honed. This does not create a sharp cutting edge. When used, there is more tooling pressure created on the radius edge. This causes problems with small “fine” turning. It becomes harder to hold tight tolerances & good finishes,consistently. MultiBar inserts are all ground to a sharp edge with no radius, greatly reducing tooling pressure. Our inserts produce more good parts and last longer than the less expensive alternatives.
One Standard bar with the widest choice of inserts.
The MultiBar will accept many different type of inserts: Front and Back turning, Cut-off, Grooving, Threading, Plunge and Turn. Working with one style bar and inserts, you will be able to cover most small turning needs.
The holder & inserts take less space than any other two cutting tools on the market!
Tooling space on gang tool lathes is always at a premium. The MultiBar under 1.1” wide, including the inserts!!!
For rigidity and longer life the MultiBar is made from hardened and ground 4140 steel.
The MultiBar is made so that you can extend the cutting tools off the face of the slide and still take a deep cut. The bar can be used for heavy roughing cuts, or fine, precise finishing work.
Specially designed geometries help take deeper cuts.
The back turning, plunge and turn inserts will cut to 3 times their width. You can do more back work resulting in fewer secondary operations.
The inserts and bar can be used for larger internal cutting.
There is enough relief in the insert.
Try the MultiBar system with the starter kit.
The MultiBar has so many possible uses. We offer a Starter Kit that will help you experiment with the entire line of inserts. After you have tried this bar, and specially ground inserts, we are sure you will be sold on the MultiBar!
| MultiBar with 5/8" round shank |
| Heavy duty multibar 5/8" shank |
| Torx T-7 wrench |
| Screw for insert - 2.40-064 |
|
 |
|||||||||||||||||
